Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Houston weather

Power’s back but the AC isn’t

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer Set the thermostat to Off, switch both AC breakers fully off and back on, wait five minutes, then set the thermostat to Cool and give it another five. Most systems come back with that. If the outdoor unit hums without starting, or a breaker trips, the outage or the surge that came with it has damaged a part.

Time
15 minutes
You’ll need
Nothing
Cost
Nothing
  1. Thermostat to Off

    This stops the system trying to start while you work on the breakers.

  2. Reset both breakers

    One for the indoor unit, one for the outdoor unit. Push each fully off, then on, even if it does not look tripped.

  3. Check the thermostat

    If the screen is blank, replace the batteries. Some thermostats lose their settings in an outage and need the mode and temperature set again.

  4. Wait five minutes

    Refrigerant pressures need time to equalize. Starting a compressor against high pressure is hard on it.

  5. Thermostat to Cool

    Set it a few degrees below the room temperature. Most systems hold the outdoor unit off for three to five minutes as protection. A delay is normal.

  6. Go outside and listen

    The fan on top should be spinning and the unit should sound the way it always does.

Stop and call if

  • The outdoor unit hums or buzzes but nothing turns
  • A breaker trips when the system tries to start
  • The lights are still dimming or flickering. Leave the system off until the power is steady.
  • You smell burning at the indoor or outdoor unit
Call 832-484-9595

What an outage does to an air conditioner

PartWhy it failsWhat you notice
CapacitorThe most surge-sensitive part in the outdoor unitA hum with no fan or compressor
ContactorContacts weld or burnThe unit will not start, or will not stop
Control board or transformerVoltage spikes on the low-voltage sideNothing responds, or the thermostat is blank
CompressorLow voltage (a brownout) makes it draw heavy current and overheatBreaker trips, or the unit runs without cooling

Brownouts do more damage than clean outages. If the lights dim badly and stay dim, switch the air conditioner off at the thermostat until the power recovers.

Running an AC on a generator

  • Starting is the hard part. A central air conditioner needs several times its running power for the instant it starts. Many portable generators that could run it cannot start it.
  • A soft-start kit helps. Fitted to the outdoor unit, it reduces that starting surge and can bring a central system within reach of a smaller generator.
  • A window unit is the practical answer for a portable generator. Cool one room and keep the refrigerator going.
  • Standby generators that start automatically are sized for the whole house, air conditioning included.
  • Use a transfer switch. Never plug a generator into a wall outlet. It sends power back up the line and can kill a utility worker.
  • Keep it outside, at least 20 feet from the house, with the exhaust pointing away. Generators produce carbon monoxide, and garages and porches are not far enough.

Questions people ask us

Should I turn the AC off when the power goes out?

Yes. Set the thermostat to Off so the system does not restart into a surge or a brownout the moment power returns. Switch it back on once the lights are steady.

Is a surge protector for the AC worth it?

In Houston, usually. It is a small part fitted at the outdoor unit that absorbs spikes before they reach the compressor and controls.

The AC runs after the outage but does not cool. What now?

The fan is running without the compressor, most likely from a failed capacitor. Turn it off and see AC blowing warm air.

Power’s back and the AC isn’t? Call us.

832-484-9595