Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Heating

Furnace clicks but won’t light: what to check

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer A gas furnace starts in a fixed order, and it stops at the first step that fails. Watch one start-up through the little window in the furnace door. Where it stops tells you, and us, what is wrong. The most common culprit is a dirty flame sensor: the burners light, then go out a few seconds later.

Time
15 minutes
You’ll need
A flashlight, a new filter
Cost
Nothing to diagnose

How a furnace starts

When the thermostat calls for heat, a modern gas furnace does this, in this order:

  1. A small fan (the inducer) starts and clears the burner chamber. You hear a hum.
  2. A pressure switch confirms that fan is moving air.
  3. The ignitor glows orange, or sparks. This is the clicking.
  4. The gas valve opens and the burners light with a soft whoosh.
  5. A flame sensor confirms there is a flame. If it can’t, the gas shuts off within seconds.
  6. The main blower starts and warm air reaches the vents.

After several failed tries, most furnaces lock themselves out for a while as a safety measure.

What to check

  1. Thermostat and power

    Thermostat on Heat and set above room temperature, with good batteries. Then the furnace breaker, and the switch on or near the furnace that looks like a light switch.

  2. Close the furnace door properly

    A switch behind the lower door panel cuts power when the panel is off or crooked. If someone changed the filter recently, reseat the door.

  3. Replace the filter

    A blocked filter overheats the furnace, and it will refuse to fire until it cools and the airflow is back.

  4. Confirm the gas is on

    Check that another gas appliance works. At the furnace, the shutoff handle should be parallel to the gas pipe.

  5. Watch one start-up

    Turn the heat up and watch through the sight window. Match what you see to the list above:

    • Nothing happens at all: power, thermostat or door switch.
    • Hum, but no glow or spark: the pressure switch or the ignitor.
    • Glow or clicking, but no flame: the gas supply or the gas valve.
    • Flame for a few seconds, then out: almost always the flame sensor.
  6. Reset it once

    Switch the furnace off at its power switch, wait a full minute, and switch it back on. If it locks out again, stop there and note the blink code from the light on the control board.

Stop and call if

  • You smell gas. Leave the house, then call your gas utility and 911 from outside.
  • A carbon monoxide alarm sounds. Get everyone out and call 911.
  • It locks out again after one reset
  • You see flames rolling out of the burner area, or scorch marks on the furnace
Call 832-484-9595

Questions people ask us

Can I clean the flame sensor myself?

It is a simple part, but reaching it means working inside a gas appliance with the power off and putting it back correctly. If you are not comfortable doing that, it is a short job for a technician, and we check the rest of the ignition system while we are there.

My older furnace has a pilot light. Does this apply?

Partly. If the pilot is out, relight it following the instructions printed on the furnace itself. If it will not stay lit, the thermocouple that senses it has probably failed and needs replacing.

Why did it work last winter and not now?

Houston furnaces sit unused for most of the year. Dust settles on the flame sensor and ignitors age whether or not they are used, so the first cold night is when faults show up. Testing the heat in the fall, before you need it, avoids the rush.

Furnace still won’t light? Call us.

832-484-9595