Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Costs and decisions

R-22, R-410A, R-454B: what your refrigerant means

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer Your air conditioner uses one of three generations of refrigerant. R-22 is in systems built before 2010, is no longer made, and is expensive. R-410A is in most systems from 2010 to 2024 and is still readily serviced. R-454B and R-32 are in new systems from 2025. The three cannot be mixed, and you cannot switch a system from one to another.

Which one do you have?

Look at the data plate on the outdoor unit, a metal label on the back or side. It names the refrigerant directly, as R-22 (sometimes HCFC-22), R-410A, R-454B or R-32. The year the system was made is a good second clue: see how old is my AC?

RefrigerantIn systems builtWhere it standsWhat it means for you
R-22 (“Freon”)Before 2010Production ended in the United States in 2020. Only recycled stock remains.Any repair involving refrigerant is costly. A significant leak usually tips the decision toward replacement.
R-410A (“Puron”)Most systems from 2010 to 2024, and some earlierNo longer used in new home systems. Still produced for servicing, in shrinking amounts.Fully repairable today. Expect the price to rise over the coming years.
R-454B or R-322025 onwardThe current standard.Nothing to worry about. These are classed as mildly flammable, so the equipment is designed with safeguards for it.

Refrigerant is not fuel

An air conditioner does not use up refrigerant. It circulates the same charge for its whole life in a sealed loop. If a system is low, it has a leak.

That is why “topping off” is rarely an answer. Adding refrigerant without finding the leak means paying for it again, usually the following summer, and running low in the meantime damages the compressor. The right repair is to find the leak, fix it, then charge the system to the manufacturer’s specification.

Signs a system is low

  • Ice on the copper lines or the indoor coil.
  • Air from the vents that is cool but not cold. See AC blowing warm air.
  • A system that runs constantly in weather it used to handle.
  • Hissing or bubbling at the indoor unit.
  • Oily residue on the copper lines or fittings.

What cannot be done

  • Mixing refrigerants. Each system is built for one. Mixed refrigerant ruins the charge and has to be recovered and replaced entirely.
  • Converting an R-410A system to R-454B or R-32. The newer refrigerants need equipment designed for them.
  • Putting a new outdoor unit on an old R-22 indoor coil. The two halves must match.
  • Handling it yourself. Buying and handling refrigerant requires an EPA certification.

Substitute refrigerants exist for R-22 systems. They can keep an old system alive, but they require removing all the R-22 first and usually cost some cooling capacity. They make sense as a bridge, not a long-term plan.

Questions people ask us

How much refrigerant does my AC hold?

It varies with the size of the system and the length of the copper lines. The factory charge is printed on the data plate, and the installer adjusts it for the line length.

My R-22 system works fine. Do I need to replace it?

No. A sealed system that is not leaking can run for years. The refrigerant only becomes an issue when a repair needs it. That is the time to compare repair and replacement.

Is the new refrigerant dangerous?

R-454B and R-32 are classed as mildly flammable, which means they are difficult to ignite and burn slowly. New equipment is designed around that, and installation follows updated safety codes.

Told you need refrigerant? Get a second opinion.

832-484-9595