Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Costs and decisions

SEER2 ratings, explained for Houston

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer SEER2 measures how much cooling an air conditioner delivers per unit of electricity over a season. Higher is more efficient. New central air conditioners installed in Texas must be at least 14.3 SEER2 for most home sizes. In Houston, where the system runs most of the year, a step or two above the minimum can be worth it. The very top ratings rarely pay for themselves on efficiency alone.

What the number means

SEER stands for Seasonal Energy Efficiency Ratio: cooling delivered over a season, divided by the electricity used. Think of it as miles per gallon for an air conditioner.

In 2023 the test behind the number changed to reflect real ductwork more closely, and the result is called SEER2. The same equipment scores a little lower on the new test, so the two scales cannot be compared directly.

Older SEERRoughly equals
14 SEER13.4 SEER2
15 SEER14.3 SEER2
16 SEER15.2 SEER2
18 SEER17.1 SEER2

The minimum in Texas

  • Central air conditioners under 45,000 BTU (up to 3.5 tons): at least 14.3 SEER2.
  • Larger home units, 4 and 5 tons: at least 13.8 SEER2.

For comparison, systems installed before 2006 could be as low as 10 SEER, and from 2006 to 2014 the minimum was 13. If your system dates from the early 2000s, even today’s legal minimum uses roughly a third less electricity for the same cooling.

What is worth paying for in Houston

TypeHow it runsWhy it matters here
Single-stageFull blast or offLowest cost. Fine in a well-sized system.
Two-stageA low setting most of the time, high when neededLonger, gentler cycles remove more humidity. A good middle choice for this climate.
Variable-speedAdjusts continuouslyThe best humidity control and the quietest. Costs the most to buy and to repair.

The efficiency number gets the attention, but in Houston the humidity control that comes with two-stage and variable-speed equipment is often what people notice day to day.

What matters as much as the rating

  • Correct sizing. An oversized high-SEER2 system short cycles and wastes its rating. See what size AC your house needs.
  • Ductwork. Leaky ducts in the attic can cancel the gain from a better unit.
  • Installation. The rating is earned in a lab. Refrigerant charge and airflow set on the day decide whether you get it at home.
  • A matched pair. The rating applies to a specific outdoor unit with a specific indoor coil. Ask for the certified rating of the combination being quoted.

Questions people ask us

Is the highest SEER2 always the best buy?

No. Each step up costs more and saves less than the one before. If you plan to stay for many years, a mid-range system usually gives the best return. If you may move soon, the minimum is reasonable.

How do I find the rating of my current system?

Look for the yellow EnergyGuide label on the outdoor unit, or give us the model numbers of the indoor and outdoor units and we can look it up.

What is EER2?

Efficiency at one fixed, hot test condition instead of across a season. It tells you how the system performs on the hottest afternoons, which matters in Houston.

Comparing quotes? We’ll walk you through them.

832-484-9595