Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Costs and decisions

What size AC does my house need?

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer Air conditioners are sized in tons, and one ton is 12,000 BTU of cooling per hour. Most Houston homes need roughly one ton for every 500 to 700 square feet, but that is only a starting point. The right size comes from a load calculation on your actual house, and it is often smaller than the unit already there.

Rough sizes for Houston homes

House sizeTypical range
1,000 to 1,300 sq ft2 to 2.5 tons
1,400 to 1,800 sq ft2.5 to 3.5 tons
1,900 to 2,400 sq ft3.5 to 4 tons
2,500 to 3,000 sq ft4 to 5 tons, often split between two systems
Over 3,000 sq ftTwo systems, sized per floor or zone

Treat this table as a sanity check, not a specification. Two houses of the same size can need a ton apart, depending on what follows.

What changes the answer

  • Insulation and age. A well-insulated newer home needs far less cooling per square foot than a 1970s house.
  • Windows. How many, which way they face, and whether they are single or double pane. West-facing glass is the big one.
  • Ceiling height. Square footage ignores it; your air conditioner cannot.
  • Ductwork. Leaky ducts in a hot attic can waste a large share of the cooling before it reaches a room.
  • Shade and orientation. Mature trees and a north-south roofline both help.
  • People and habits. A full house and a busy kitchen add heat.

A proper load calculation, known in the trade as a Manual J, puts numbers on each of those. Ask any contractor quoting a new system how they arrived at the size. “Same as what’s there” is not a calculation.

Why bigger is not better

An oversized air conditioner cools the air near the thermostat in a few minutes and shuts off. That sounds efficient and is the opposite:

  • It never runs long enough to pull the humidity out, so the house feels clammy at the right temperature.
  • It starts and stops constantly, which is what wears compressors out.
  • Rooms far from the thermostat never catch up.
  • It costs more to buy and more to run.

In Houston, where humidity is half the battle, a correctly sized system that runs long and steady is more comfortable than a bigger one that sprints and rests.

  1. Find the data plate

    A metal label on the back or side of the outdoor unit.

  2. Look at the model number

    Somewhere in it is a two-digit number divisible by 6: 18, 24, 30, 36, 42, 48 or 60. That is the capacity in thousands of BTU.

  3. Divide by 12

    24 is 2 tons, 30 is 2.5, 36 is 3, 42 is 3.5, 48 is 4, and 60 is 5 tons, the largest single home system.

Questions people ask us

My current unit is 4 tons. Should the new one be 4 tons?

Not automatically. Many older systems were oversized, and if you have added insulation, new windows or sealed ducts since, the house needs less than it did. A new calculation settles it.

Can an undersized AC damage itself?

It will run constantly on hot days and wear faster, but slightly small is easier to live with than too large. A system that holds the mid-70s on the hottest afternoon is about right.

Does a higher SEER2 rating mean more cooling?

No. Tonnage is how much cooling; SEER2 is how much electricity it takes to deliver it.

Want your house measured properly? Call us.

832-484-9595