Open 24 hours, every day 832-484-9595
  1. Home
  2. Guides
  3. Air conditioning

Thermostat blank or not working

By Topnotch Air Systems, Texas HVAC license TACLB00084529E
Updated November 2026

The short answer A blank thermostat is usually dead batteries, or a system that has lost power. In Houston, a full drain pan is a frequent cause of the second one: the safety switch cuts power to the thermostat along with everything else. Replace the batteries, check the breakers, then look in the pan.

Time
10 minutes
You’ll need
Fresh batteries
Cost
A pack of batteries
  1. Replace the batteries

    Most thermostats pull off their wall plate or have a battery door on the side. Replace all the batteries together. A low-battery thermostat can look alive and still fail to switch the system.

  2. Check the mode and the setting

    Mode on Cool or Heat, not Off. Temperature set a few degrees past the room temperature. Fan on Auto. It sounds obvious, and it is very often the answer.

  3. Look for a hold or a schedule

    Programmable and smart thermostats follow a schedule unless told otherwise. If it keeps changing the temperature by itself, a schedule is running. Press Hold, or edit the schedule.

  4. Check the breakers

    A thermostat with no batteries is powered by the system. If the screen is blank and there are no batteries to change, reset the indoor unit’s breaker once.

  5. Look in the drain pan

    If the indoor unit is in the attic, check the pan beneath it. On many systems a full pan cuts power to the thermostat. Clear the drain and the screen comes back.

  6. Wait five minutes

    After any reset, most thermostats hold the compressor off for a few minutes to protect it. A message such as “wait” or a flashing snowflake is that delay, not a fault.

Thermostat problem or AC problem?

What happensPoints to
Screen blank, comes back with new batteriesThermostat batteries.
Screen blank, no batteries to changeNo power from the system: breaker, drain safety switch or a blown fuse.
Screen fine, you hear a click, nothing startsThe system, not the thermostat. See AC won’t turn on.
Screen fine, no click at allThe thermostat or its wiring.
Room temperature reads several degrees offA thermostat in the sun or a draft, or a failing sensor.
System runs but ignores changesA schedule or hold, or a failed thermostat.
Smart thermostat keeps dropping off Wi-Fi or restartingIt is not getting steady power from the system and may need a common wire added.

Call us if

  • The screen stays blank after new batteries and a breaker reset
  • The thermostat clicks but the system never starts
  • The breaker trips again
  • A new thermostat was just installed and the system has not worked since
Call 832-484-9595

Questions people ask us

How long do thermostats last?

Often ten years or more. Replace one when it reads the wrong temperature, switches erratically, or you want scheduling it does not have.

Can I install a smart thermostat myself?

Often, yes, if your wiring includes a common wire and the system is a standard single-stage one. Photograph the old wiring before disconnecting anything and turn the breaker off first. Systems with two stages or zoning are worth having wired by a technician.

My thermostat says 74 but the house feels warmer. Why?

Humidity. At 60 percent humidity, 74 degrees feels noticeably warmer than it does at 45 percent. If the air feels sticky, the system may be short cycling or oversized.

Thermostat fine but still no cooling? Call us.

832-484-9595